by Rodney Jones
2. June 2009 08:53
How to recalibrate the Tacktick to the Hull transducer
- Make sure Tacktick is off.
- Power up Tacktick by holding the ● button for 2 seconds
- Press the ● button once short and then again and hold to enter the set up mode
- Press the ▼ button until ‘Options” is displayed (don’t hold the ▼ button down since this will turn the unit off.)
- Press the ► button to display “Auto Network”
- Press the ● button to activate the calibration process. The unit needs to be held close (20cm) to the light grey coloured box in side the hull the unit will count down from 15 to give you time to hold the unit in place that close.
- After the initially 15 seconds the unit will count down from 60 whilst displaying “join”. During the countdown the unit will double beep to confirm the joining of the unit.
- It is recommended to wait until the countdown is finished before taking the unit further away then 20cm from the grey box.
- Press and hold the ● Button for 2 seconds to exit the set up mode.
- Ready to Race!